Vampire Deauther 2.4Ghz & 5Ghz

🔌 BW16 to Flipper Zero Wiring

BW16 (22 pins)                         Flipper Zero GPIO Header
================                       =========================
Pin 1  - 3V3      (Red)           ---> Pin 9   - 3.3V  ✅
Pin 2  - GND      (Black)         ---> Pin 18  - GND   ✅
Pin 3  - PA07_TXD (Any Color)     ---> Pin 14  - RX (Flipper receive data) ✅
Pin 4  - PA08_RXD (Any Color)     <--- Pin 13  - TX (Flipper transmit data) ✅
            

⚠️ Note: Used black PCB 22 pins BW16(RTL8720DN). 30 pins version doesn't work properly (blue PCB).

🔧 Leds indication:
Solid green = BW16 ready
Blinking blue = Scanning Wi-Fi networks
Blinking red = Deauthentication of single network(press RESET button on board to stop it)
Blinking red (slower) = Deauthentication of all networks(press RESET button on board to stop it)
Blinking green = Beacon spam. (Pressing back button on Flipper stops it)
Note: Memory fills during deauth, may need RESET board

💻 Standalone Use: Can be used without Flipper Zero via Arduino IDE at 115200 baud

Serial Monitor Commands:

• AT+SCAN - Scan WiFi networks and save them to memory as indexed list
• AT+DEAUTHIDX= - = followed by the index number Deauth a single network(press RESET button to restart BW16)
• AT+DEAUTHIDX=ALL - Deauth all networks in index (press RESET button to restart BW16)
• AT+BEACONRANDOM=Vampel - Spam networks with suffix "Vampel 001, Vampel 002... up to 50"
• AT+STOP - Stop current operation (Note: Memory fills during deauth, may need RESET)

With Flipper Zero, the menu guides you through all options easily.
Note: some Devices have PMF enabled (cant Deauth)

🚀 Future Features

• Change baud rate to 1500000 for faster flashing
• Ability to read & save firmwares from BW16 & any Ameba board
• Thanks to all the developers of SharpRTL872xTool & tesa-klebeband, my codes was based on.